Metal Roof Replacement in Lakeland, FL

Replacing a metal roof in Lakeland comes down to three choices: the panel type (exposed-fastener 5V crimp or concealed-fastener standing seam), the gauge, and what happens to the deck underneath. Residential panels are usually 24 or 26 gauge steel. In Florida, the system also has to be backed by a state product approval, a Miami-Dade acceptance, or an engineered design with calculations. Titan Blue Ventures puts new metal roofs on houses, mobile homes and outbuildings around Lakeland under state roofing license CCC1337399, and the estimate is free.

5V Crimp or Standing Seam

5V crimp

5V crimp is one of the most common metal panels on Florida homes and farm buildings. Each sheet covers 24 inches with V-shaped ribs, and the screws go through the face of the panel. It costs less and goes on faster. The tradeoff is upkeep: exposed screws and their washers need checking and, over the years, replacing.

Standing seam

Standing seam panels lock together at raised seams and fasten to the deck with hidden clips or a fastener flange, so no screws pierce the weather surface. That leaves far fewer places for water to get in, and manufacturers describe it as a low-maintenance system. It costs more up front.

Gauge

Lower numbers mean thicker steel. HomeGuide and Metal America both name 24 and 26 gauge as the usual residential choices, and HomeGuide notes that areas with extreme weather call for a thicker panel.

What Changes Under the New Roof

Decking

Tearing off an old roof is the only way to see the deck. Central Florida supplier Mid Florida Metal Roofing Supply points out that tear-off often exposes rotted decking, and that a low quote may leave out tear-off, trim, decking, permits or disposal. Ask what each quote includes before you compare prices.

Deck fastening and the water barrier

The same Florida statute that governs shingle reroofs, 553.844, applies here: a new metal roof on a site-built single-family home must come with a secondary water barrier and upgraded fastening of the deck to the framing.

Product approval and wind

Florida enforces wind tests for metal roof systems, including UL 580 and UL 1897, and product approvals are searchable on floridabuilding.org. When you get a quote, ask for the panel’s approval number, the fastening pattern and the installation method, so you know the system is being installed the way it was tested.

Metal Roofs on Lakeland Mobile Homes

About 15 percent of Lakeland’s homes are mobile homes, per Census estimates, and Hurricane Milton hit them hardest: in October 2024, most of the 27 structures city assessors listed as destroyed were in mobile home parks. Metal is light, which suits mobile homes, many of which have low-slope roofs. Federal HUD standards place Polk County in Wind Zone II, with a 100 mph design wind speed for manufactured homes.

Polk County requires a permit for all re-roofing in unincorporated areas, including mobile homes and park trailers. Homes inside city limits go through Lakeland’s own building inspection office instead. Code-wise, metal roofs today follow the 2023 8th Edition of the Florida Building Code, and the 9th Edition replaces it on December 31, 2026.

What Metal Costs in Central Florida

Prices vary by pitch, panel type and how much of the old roof comes off. Mid Florida Metal Roofing Supply’s 2026 guide suggests planning on roughly $8 to $15 a square foot in Central Florida. HomeGuide lists metal roofs for single-wide mobile homes at $2,500 to $19,200 and double-wides at $5,000 to $32,000. Use those as rough planning numbers only, since your quote depends on your roof.

Converting From Shingles

We also convert worn shingle roofs to metal. If you are weighing the two, our shingle roof replacement page for Lakeland walks through the shingle side. Our main metal roof replacement page and a rundown of everything we do in Lakeland cover the rest. For a free estimate, contact us or call or text (863) 289-0531.